Този урок показва как да създадете сключена водоснабдителна инсталация. Последната е разположена в еднофамилна двуетажна сграда със сутерен.
Modules and program configuration
InstalSystem 5 software package with the following modules:
Питейни-битови водни системи
Tap water extensions
Recommended: sanitary system pipe catalogues containing direct U-shaped tap water connection, which guarantees lack of no-flow zones within the system
Initial state
The initial state file is located in the Project table, and it contains the building graphic structure and radiant sanitary system, which needs to be completed with a loop installation on the storey. За повече информация, моля вижте:Design of water supply system installation
Steps to perform
Turning on the program and project general data configuration
Turn the program on.
Load the project file - Single-family building water installation initial state, isproj.
Installation edition
Select storey No. 1.
Draw hot and cold water pipe feeds, so that a loop installation is created in room 1.5. Файл:Ring instalation.png1.Creating a loop installation.
With your mouse, select the area with terminal units and choose Автоматично свързване на приемници.
If needed, modify pipe feed ordinates to evade doors. To do so, insert additional division points for the pipe feed passing through the door opening. it is necessary to impose a correct ordinate. The correction of imposed values should be verified in the 3D изглед window. Файл:Obejscie drzwi 12.11 end.png2. Omitting the door opening
Verify if the circulation circuit has been closed properly on the storey. Файл:Zamknięcie cyrkulacji.png3. Closing the circulation circuit on the first storey
Verification of the correctness of installation structure
Verify correctness of the installation structure using the Провери връзки function (shortcut: Shift + F2).
