Бърз проект на лъчисто отопление и охлаждане

Продукт	InstalSystem 5
Вид статия	DESIGN APPLICATION
Актуално съдържание за версия	IS 5.0 Beta 31

Scope of lesson

This article presents the quick way of designing radiant heating/cooling loop circuit systems (wet and dry type). The aim of this simple approach to designing is to obtain approximate heat and flow results and to draw up a rough bill of materials.

Modules and program configuration

InstalSystem 5 with the module:

• Radiant loop heating systems.

Inital state

The building structure (storeys, rooms) is defined, plans of storeys are provided. The values of heat load in rooms are specified for heating and cooling.

Steps to perform

The selected steps to perform are included in the basic course of radiant heating and cooling design with loop circuit systems (wet and dry type) and constitute a simplified form of operations described in:

• Design of radiant heating floor and wall installation,
• Calculation of cooling capacity for radiant systems (floor, wall or ceiling).

The steps that are included in the articles mentioned above and are not included in this article are optional in the quick design.

Specify catalogues

1. Каталози and select catalogues of:
   • Лъчисти системи
   • Тръби и фитинги

Specify general data

1. Изчислителни раздели (модули) and select range:
   • Отоплителни системи
   • Охладителни системи
2. Сграда и околности
   • Климатични данни - select Град
3. Термални системи - append information for:
   • Разпределителна система
     • Виртуални връзки на лъчисти системи - check that Създай виртуални връзки, когато няма графични връзки is enabled
     • Видове и данни по подразбиране
   • Лъчисти системи
     • Подови системи
     • Стенни системи
     • Колектори, фигинги и контрол
     • set Кангали and Метод за листване на количества на ЛО to

Edit installation - radiant system

Отоплителна/Охладителна зона

1. Insert Отоплителна/Охладителна зонаs into rooms using the Под (във всяко помещение) function. Repeat the operation for each storey. Insert Стена (ръчно) in selected rooms.
   
   
   

Колектори

1. Place manifolds in approximately defined locations.
   

Calculations and diagnostics

Verification of results

1. Verify calculation results, diagnostics and bills of materials paying special attention to:
   • Количество на елементи от лъчисто отопление for all the key components of the system.